Products Description

Compressors are highly sensitive to intake resistance; every 1 kPa drop in intake pressure leads to a significant increase in power consumption and a reduction in discharge capacity. During the design phase, the face velocity must be strictly controlled (typically within the range of 2.0–3.5 m/s). Furthermore, preference should be given to corrugated (sinusoidal) or flat, straight fins, while avoiding louvered fins-which impose excessive resistance-unless the gas is exceptionally clean.
- Customizable Dimensions: Dimensions and capacities can be customized to meet specific project requirements.
- High Thermal Efficiency: Features copper tubes and aluminum fins for superior heat transfer and low air resistance.
- Corrosion Resistance: Natural resistance to corrosion in humid environments; optional anti-corrosion coatings available.
- Compact Design: Optimized structure saves space while maintaining high heat transfer performance.

Intake air cooling is often accompanied by condensation, and fine dust may still penetrate the upstream filters. If the fin spacing is too narrow, condensed water can form "bridges" that block the airflow passages, thereby increasing resistance. It is recommended to maintain a fin spacing between 2.5 mm and 4.0 mm; if the intake air has a high dust content, this spacing should be increased further-to more than 4.0 mm-to facilitate cleaning by blowing.

When the inlet air temperature drops below the dew point, a large amount of condensed water will precipitate. Sufficient space must be reserved on the outlet side of the heat exchanger to install a wire mesh demister or a baffle-type gas-liquid separator to prevent liquid droplets from being carried into the compressor by high-speed airflow and causing "liquid hammer" or impeller erosion. The bottom water collection tank must be equipped with an automatic drain valve and ensure sufficient slope.
- OEM & ODM Services: Full customization support for designs, tube arrangements, and fin configurations.
- ISO 9001 Certified: Manufacturing process certified with 100% quality and performance inspection before delivery.
- Fast Response Time: Technical team aims to respond to inquiries within 12 hours on weekdays.
- Flexible Production: Capable of handling both mass production and small-batch custom orders with skilled technicians.

Uses and Functions
• Increasing compressor capacity (enhancing throughput and efficiency): According to the gas state equation, lower temperatures result in higher gas density. Reducing the intake temperature-typically by 3°C to 5°C-increases the mass flow rate of the gas drawn into the compressor by approximately 1% to 1.5% for a given suction volume, thereby directly boosting the unit's total gas output.
• Reducing compressor shaft power (energy conservation and consumption reduction): Gases are easier to compress at lower temperatures. Lowering the intake temperature mitigates the temperature rise associated with the polytropic compression index, which in turn reduces the power required to compress each cubic meter of gas. This energy-saving effect is particularly significant in large-scale centrifugal and screw-type compressors.
Roles and Functions
• Inlet Pre-dehumidification and Drying (Reducing Load and Preventing Moisture): When warm, humid air or process gas is cooled below its dew point, water vapor condenses and is removed via a drainage system. This not only reduces the load on the compressor's interstage coolers and downstream drying equipment but also prevents moisture from diluting the lubricating oil-a critical factor for oil-lubricated compressors.
• Discharge Temperature Control (Ensuring Operational Safety): Excessively high inlet temperatures can cause a sharp rise in the discharge temperature at the final compression stage. Pre-cooling the intake stream lowers the baseline temperature, effectively preventing high discharge temperatures from triggering emergency shutdowns. It also mitigates risks such as carbon deposits in the lubricating oil, the premature aging of seals, and potential combustion or explosion hazards.

Hot Tags: compressor inlet air cooling stainless steel tube aluminum fin heat exchanger, China compressor inlet air cooling stainless steel tube aluminum fin heat exchanger manufacturers, suppliers, factory, active freeze drying, freeze dried processing equipment, freeze dryer for taxidermy for sale, industrial freeze dryer machine, large freeze dryer machine, small scale freeze dryer
